Maintenance and repair instructions – Bolens BL3100 User Manual

Page 15

Advertising
background image

15

MAINTENANCE AND REPAIR INSTRUCTIONS

MAINTENANCE SCHEDULE

Perform these required maintenance procedures at the
frequency stated in the table. These procedures should
also be a part of any seasonal tune-up.

NOTE: Some maintenance procedures may require

special tools or skills. If you are unsure about
these procedures take your unit to any non-road
engine repair establishment, individual or
authorized service dealer.

NOTE: Maintenance, replacement, or repair of the

emission control devices and system may be
performed by any non-road engine repair
establishment, individual or authorized service
dealer.

In order to assure peak performance of your engine,
inspection of the engine exhaust port may be necessary
after 50 hours of operation. If you notice lost RPM, poor
performance or general lack of acceleration, this service
may be required. If you feel your engine is in need of this
inspection, refer service to any non-road engine repair
establishment, individual or authorized service dealer for
repair. DO NOT attempt to perform this process yourself
as engine damage may result from contaminants
involved in the cleaning process for the port.

FREQUENCY

MAINTENANCE REQUIRED

REFER TO

Before starting engine

Fill petrol tank with fresh petrol

Page 10

Every 10 hours

Clean and re-oil air filter

Page 15

Every 25 hours

Check and clean spark arrestor
Check spark plug condition and gap

Page 16
Page 17

Every 50 hours

Inspect exhaust port and spark arrestor screen for clogging or
obstruction to assure maximum performance levels

Page 16

WARNING:

To prevent serious injury, never

perform maintenance or repairs with unit
running. Always service and repair a cool unit.
Disconnect the spark plug wire to ensure that
the unit cannot start.

AIR FILTER MAINTENANCE

Removing the Air Filter/Muffler Cover

1. Place the choke lever in the PARTIAL choke position (B).

NOTE: The choke lever must be in the PARTIAL choke

position (B) to remove the air filter/ muffler cover.

2. Remove the four (4) screws securing the air

filter/muffler cover (Fig. 22). Use a flat blade or
T-20 Torx bit screwdriver.

3. Pull the cover from the engine. Do not force.

WARNING: To avoid serious personal injury,
always turn your unit off and allow it to cool
before you clean or service it.

Cleaning the Air Filter

Clean and re-oil the air filter every 10 hours of operation.
It is an important item to maintain. Failure to maintain the
air filter will VOID the warranty.

1. Remove air filter/muffler cover. Refer to Removing

the Air Filter/Muffler Cover.

2. Turn cover over and look inside to locate the air filter.

Remove the air filter from inside the air filter/muffler
cover (Fig. 23).

3. Wash the filter in detergent and water (Fig. 24). Rinse

the filter thoroughly. Squeeze out excess water. Allow
it to dry completely.

Choke Lever

Screws

Screws

Partial Choke

Position (B)

Fig. 22

Fig. 23

Fig. 24

Air Filter

Inside Muffler

Cover

Advertising