Bolens BL3100 - Manual (Page 18)

18
MAINTENANCE AND REPAIR INSTRUCTIONS
CLEANING THE UNIT
Use a small brush to clean off the outside of the unit.
Do not use strong detergents. Household cleaners that
contain aromatic oils such as pine and lemon, and
solvents such as kerosene, can damage plastic housing
or handle. Wipe off any moisture with a soft cloth.
CLEANING THE VACUUM BAG
1. Empty the bag after each use to avoid deterioration
and obstructing air flow, which will reduce the
performance of the vacuum.
2. Wearing eye protection and a dust mask, clean the
bag as needed. Turn the bag inside out after initial
emptying and vigorously shake out dust and debris.
3. Wash the bag once a year or more often if needed:
a. Remove the vacuum bag.
b. Turn bag inside out.
c. Hang it up.
d. Hose it down thoroughly.
e. Hang to dry.
f. Turn bag right-side out and reinstall.
STORAGE
• Never store a unit filled with petrol where fumes may
reach an open flame or spark.
• Allow the engine to cool before storing.
• Store the unit locked up to prevent unauthorized use
or damage.
• Store the unit in a dry, well-ventilated area.
• Store the unit out of the reach of children.
LONG TERM STORAGE
If you plan on storing the unit for an extended time, use
the following storage procedure:
1. Drain all petrol from the petrol tank into a container
with the same 2-cycle petrol mixture. Do not use
petrol that has been stored for more than 60 days.
Dispose of the old petrol/oil mix in accordance to
Federal, State and Local regulations.
2. Start the engine and allow it to run until it stalls. This
ensures that all petrol has been drained from the
carburetor.
3. Allow the engine to cool. Remove the spark plug and
put 30 ml (1 oz.) of any high quality motor oil or
2-cycle oil into the cylinder. Pull the starter rope
slowly to distribute the oil. Reinstall the spark plug.
NOTE: Remove the spark plug and drain all of the oil
from the cylinder before attempting to start the
unit after storage.
4. Thoroughly clean the unit and inspect it for any loose
or damaged parts. Repair or replace damaged parts
and tighten loose screws, nuts or bolts. The unit is
ready for storage.
TRANSPORTING
• Allow the engine to cool before transporting.
• Drain petrol from unit.
• Tighten petrol cap before transporting.
• Secure the unit while transporting.
WARNING: To avoid serious personal injury,
always turn your unit off and allow it to cool
before you clean or service it.
ACCESSORIES/ REPLACEMENT PARTS
2-Cycle Oil . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 147543
Spark Plug . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 610311
Petrol Cap . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 180000
Vacuum Bag . . . . . . . . . . . . . . . . . . . . . . . . . . . . .182416
Blower/Vacuum Tube Assembly . . . . . . . . . . . . .182415
Shoulder Harness . . . . . . . . . . . . . . . . . . . . . . . .682075
For specific replacement parts, refer to the parts list
located on the inside back cover of this manual.