RCBS Lube Die - Manual (Page 6)

Push the rubber seal ring up to
expose the fill hole. Fill the Lube Die with RCBS Case
Lube-2.
GENERAL INFORMATION
Lubricating cases prior to resizing is an important and necessary step in the
reloading process. The use of the RCBS Lube Die eliminates the sometimes
unpleasant method of lubricating cases by hand. With the Lube Die a cartridge
is lubricated and decapped in a single motion.
• Faster and easier than hand lubricating
• Keeps hands clean when reloading
• Less handling of cases prior to reloading
• Standard 7 /
8
-14 thread fits most presses
• Easy to refill with RCBS Case Lube-2
The RCBS Lube Die can be use in single-stage presses or progres
sive reloading tools with a minimum of four stations.
There are four Lube Dies available. Each Lube Die lubes and decaps the
case in one operation. See the Lube Die Compatibility Chart for the correct
Lube Die to use.
The following instructions are for using the Lube Die in a progressive
reloading tool with a minimum of four stations.
PREPARING THE LUBE DIE
Lay the Lube Die on its side. Push the rubber seal ring toward the top of the