RCBS Lube Die - Manual (Page 9)

HELPFUL HINTS
• Do not over-fill the lube retainer with case resizing lubricant. As a
general guide, squeeze (with light pressure) the Case Lube-2
bottle for 8 to 10 seconds when filling the lube retainer.
• Slide the rubber seal ring above the fill hole to increase the flow of
lubricant while reloading.
LUBE DIE STORAGE
The die may be left in the reloading press or stored in its plastic storage
box. The die should be stored in the vertical position when full of lubricant. A
case must be left in the die to prevent lubricant leakage. Prior to using the die
again, remove the case and follow the procedures outlined in “USING THE
LUBE DIE.” If excessive lubricant collects on the decapping unit, remove it
from the die and wipe with a damp cloth.