Reloop IQ2 MIDI - Manual (Page 38)

ENGLISH
37
In this mode Gain, 3-band EQ and linefaders are analogue in audio mode. This means that the virtual
Traktor signal can be directly manipulated with the mixer.
NOTES!
- For the External Mixer Mode select the mapping “IQ2 MIDI External”
- Via this mapping you can control effects and loops for decks A-D
- To do so put the FX MIDI Switch -46- to the On position
- Make sure that the Crossfader Effect Switch -15- is in the Off position as otherwise the cross-
fader effects will be activated
ATTENTION! This mapping is programmed on MIDI channel 10. Make sure that your IQ2 MIDI is
assigned on MIDI channel 10. (see chapter MIDI Channel Adjustment)
MIDI-MAPPING: IQ2 MIDI EXTERNAL
TIP! In External Mixer Mode XF MIDI should be deactivated (OFF) so that the crossfader can be
used in analogue mode for fast and precise cuts.
> AUDIO-ROUTING EXTERNAL:
In External Mode (USB 1 / 2) channel A represents output 1 / 2 (Master) and channel B represents
output 3 / 4.
Shows Active Deck
in „FX MIDI“ mode
FX Select
Deck Select A-D
FX Dry/wet
FX ON
To control Traktor
Effects & Loops,
switch to „FX MIDI
ON“ on the front
panel.
Chained effect mode:
> select effect slot 1-3
Advanced effect mode:
> select parameter 1-3
Switch to OFF
Chained effect mode:
> Push: effect select
> Turn: effect amount
Advanced effect mode:
> Push: parameter button 1-3
> Turn: parameter control 1-3
Loop Length
Loop On/Off
Choose „USB 1“ for CH A
and „USB 2“ for CH B