Reloop ADM-4 - Manual (Page 9)

9
oPeRATIon
1. Set volume control to minimum level:
Before switching on the device, turn the Volume Control -4- to minimum position (control to the left).
2. Power On:
After all connections have been completed activate the device with the ON/OFF Button -1-.
3. Volume Control:
Adjust the volume with the Volume Control -4-.
SoUnD conTRol
Use the Bass -5- and Treble Controllers -6- to lower or raise the low and high frequencies. The ideal adjustment depends on the given accomo-
dations. A heavily dampened room requires raised high frequencies whereas a reverberant room requires a reduction of the high frequencies. If
the monitors are positioned near a wall or corner the low frequencies will be raised. If the monitors are positioned in a bigger distance the low
frequencies will be lowered.
TechnIcAl InfoRMATIon
Reloop Wave 4:
- RMS power:
2 x 16W
- Type: Active 2-way system
- S/N Ratio: > 75dB
- Speaker: 10,16 cm (4”) bass, 2,54 cm (1”) tweeter
- Frequency range: 50 Hz - 20 kHz
- Impedance: 8 Ohm
- Connections: RCA, 3.5 mm Jack
- Dimensions: 196 x 260 x 153 mm
- Weight: 5.04 kg (pair)
Subject to alterations!
Illustrations similar to original product!
Misprints excepted!
Reloop Trademark
Global Distribution GmbH, Schuckertstr. 28, 48153 Münster, Germany, Fax +49.251.60 99 368
ENGLIS
CH