Revel Voice - Manual (Page 11)

Figure 9. How to connect the
VOICE speaker in a horizontal
bi-amplified system.
HORIZONTAL BI-AMPLIFIED SYSTEM
Using two amplifier channels, remove the shorting straps from the
rear panel; then connect the VOICE speaker, as shown in Figure 9.
CAUTION: Failure to remove the shorting straps when bi-
amplifying may damage some amplifiers.
NOTE: If the “gain factor” of the two amplifier channels is not identi-
cal, a means of adjusting the output level of at least one of the channels
is required. Consult your Revel dealer for specific recommendations.
VOICE Speaker
Owner’s Manual
11
VOICE Rear
Install straps for single-wired operation Note:
Remove straps
for bi-wired
or bi-amplified
operation
Install straps for single-wired operation
Low Frequency Input High Frequency Input High Frequency Level (dB)
0 +.5 -.5 +1 -1
Placement
Compensation
(See Owner's Manual) Serial Number
Revel Corporation
Chatsworth, California
Made in U.S.A.
On Top Of
Monitor Flush Mounted Stand
Mounted
(one channel shown –
use for high frequencies) (one channel shown –
use for low frequencies)
Amplifier
(rear) INPUT
Amplifier
(rear) INPUT
(“Y” Adaptor)
Multi-Channel Controller
(rear)
CENTER OUTPUT
white red
Connector Panel
Shorting
Straps
Removed
Low Frequency Input High Frequency Input
High Frequency
Level (dB)
0 +.5 -.5
+1 -1
On Top Of Monitor
Flush Mounted Stand
Mounted
Placement
Compensation
(See Owner's Manual)
Serial Number
xxxx