Revel Voice - Manual (Page 14)

Figure 11. Installing a new
VOICE panel.
Figure 12. Installing the VOICE
speaker grille.
PANEL REPLACEMENT
Although your new VOICE speaker is preassembled at the factory,
you can replace existing panels with new ones as follows:
1. Place the speaker on a soft surface. Use the enclosed hex wrench
to untighten panel bolts. Remove each panel and grille.
2. Install a new panel (see Figure 11). Start all four bolts (with
trim rings) by hand and tighten them with the hex wrench. Be
careful not to overtighten.
3. Turn the speaker over, as shown in Figure 12. Install the speaker
grille. Insert the grille tips into panel cups.
VOICE Speaker
Owner’s Manual
14
Bolt
Trim
Ring
,,
,,,,
,,,,,,
,,,,,,,,
,,,,,,,,,,
,,,,,,,,,,,,
,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,,,,,,, ,,,,,,,,,,,,,,,,,,,, ,,,,,,,,,,,,,,,,,, ,,,,,,,,,,,,,,,, ,,,,,,,,,,,,,, ,,,,,,,,,,,, ,,,,,,,,,, ,,,,,,,, ,,,,,, ,,,, ,,