RiME LITE XB WIFI - Manual (Page 13)

13
How to set Remote Control
A. Most operating way is same with the XB Prime’s Operating Instruction.
B. The differences are only a few.
1. “POWER” button
Turn on the power of Remote Control.
2. “XB” button
This button is for the start of all performances of each strobe/channel.
Press this button when you need to perform any functions of each strobe.
Press “POWER” button and select the studio group (A to E) and then select the
strobe/channel (1 to 10) and then press the “XB” button.
And now you can control all functions of selected strobe.
When pressing “XB” button for 3 seconds, it starts ACS mode can be set the exposure value
by F1.1 (1.1 f-step).
3. “CELL” button
Photocell On / Off
4. “SOUND” button
Sound On / Off
5. “PROP” button
Press it shortly: proportionally power on / free modeling lamp.
Press it for 2 or 3 seconds: modeling lamp continuously turns on / off.
6. “TEST” button
By pressing this button, test flash can be released.
7. “STROBE OFF” button
Pressing this button can turn on / off the selected strobe’s power.
You should select the strobe you want to turn on / off before pressing this button.
8. “SCAN” button
You can check the current connected strobes with this function.