RiME LITE i flash - Manual (Page 4)

“T” or High Flash Duration Mode
Ÿ This is the mode designed for a shorter flash duration for high speed photography purpose (such as
water droplet)
Ÿ To change the strobe from Normal to “T” mode, press the Mode button (Button 4 on page 2)
Ÿ The FND Display will change from Numerical to t1, t2…t7 based on the memory of the last input
value
Ÿ Turn the Power Control Dial to its right to increase power or slower flash duration (1 on page 2) and
to the Left for lower power or fast flash duration.
Ÿ The Sowest Flash Duration is indicated as t7 in the FND display (The highest flash power output)
The Fastest Flash Duration is indicated as t1 in the FND display (The lowest flash power output)
*The flash duration above measured in t0.5 and Colour Temperature in Kelvin.
(CAUTION : The strobe will store a higher power in the “T” mode. Therefore, switching the “T” mode back
to Normal Mode might result a over charge flash output. Please press the Test button 2 to 3 times to
dump all the excessive power before continue the shooting)
“C” or Stroboscopic Mode
This mode is dedicated to fire a series of High Speed flashes (5fps, 10fps or 15fps)
For the “C” mode, user can either select the “C1” for lower power flash output or “C2” for higher power
flash output.
Model t 7 t 6 t5 t4 t3 t2 t1
i2 (200w) 1/500s 1/640s 1/1250s 1/2500s 1/4000s 1/6400s 1/12800s
Colour
Temperature
5300 k 5300 k 5340 k 5450 k 5550 k 5750 k 6300 k
i4 (400w) 1/500s 1/640s 1/1250s 1/2500s 1/4000s 1/6400s 1/12800s
Colour
Temperature
5300 k 5300 k 5450 k 5450 k 5500 k 5700 k 6200 k
15fps
5fps 10fps