RiME LITE i flash - Manual (Page 5)

Please follow the steps below for engaging the “C” mode
Ÿ Make sure the flash power output is either 1.0, 1.5, 2.0 or 2.5 in the normal mode or t1 and t2 in
the Flash Duration Mode.
Ÿ Press the RPT button (3 on page 2) after select the appropriate power setting. The FND display
will show “C1” or “C2” to indicate the power setting.
Ÿ By default, the flash will fire 5fps. To set the strobe to fire 10fps or 15fps just press the RPT button.
(NOTE : The Flash Duration & Colour Temperature of the flash when performing in the “C1” or “C2”
mode is similar to “t1” and “t2”)
Modeling Light
The i-Series uses 2.5w dimmable LED for its modeling light. User can control the brightness by turning
the control knob (2 on page 2) to the right to increase the brigthness.
Cell / Slave Mode
Press the Cell button (5 on page 2) to turn on the photocell sensor.
Sound
Press the Sound button (6 on page 2) to turn on the audible (“Beep” sound) indicator for the charged
signal. (NOTE: its only work when the flash is operate in the Normal Mode)
Test
Press the Test button (7 on page 2) to test fire the flash. The Yellow colour LED on the Test Button will go
off right after the flash discharged and light up again when its charged and ready to fire.
Sync Socket
The flash support a standard 6.35mm Sync Cable Cord.
Standard RiMELITE Receiver Slot
I-series support both Swing System I & II. Remove the plastic cover and insert the Swing Receiver
module to slot gently. The indicator light on the Receiver will light up once the Flash power is On.
10fps 5fps 15fps