Rite-Ride 4134 - Manual (Page 2)

S
TEP
4 - A
DJUST THE AIR SPRING
Push the air spring up into the coil spring by hand or
with a blunt tool, such as a socket extension. DO NOT
use any thing with sharp edges or corners, as this may
damage the air spring.
When the air spring is completely within the coil
spring, remove the plug and tubing section by pushing
the collar on the fitting towards the air spring and pulling
out the tubing. Allow the air spring to return to its
normal shape.
Push the air spring to the top of the coil spring and
insert the lower support between the air spring and the
lower spring seat see Figure "D".
S
TEP
5 - R
OUTE THE AIR LINE
Cut the air line tubing into two equal lengths, making
sure the tubing is cut as squarely as possible (a "saw" cut
with a sharp knife is preferred). Select a location for the
inflation valves in a protected area, such as on the
bumper or body of the vehicle (Note: The inflation valve
will be installed in Step 6).
Insert the air line tubing into the push-to-connect
fitting on the air spring as far as possible. Route the air
line from the air spring to the desired inflation valve
location.
With the tubing routed from the air spring to the
inflation valve location, use the nylon ties supplied to
secure the air line tubing to the vehicle see Figure "E".
Be careful to avoid heat and sharp edges when fastening
the tubing to the vehicle. Route the tubing away from
the exhaust system.
C
OIL
-R
ITE
I
NSTALLATION
P
ROCEDURE
P LEASE TAKE ALL NECESSARY SAFETY PRECAUTIONS WHEN
INSTALLING YOUR C OIL -R ITE KIT .
FIGURE "A"
FIGURE "B"
FIGURE "C"
INSTALL PLASTIC
PLUG IN UPPER
SPRING SEAT
PLUG
AIR LINE
COIL-RITE
AIR SPRING
AIR
INLET