SCHOEPS KFM 360 - Manual (Page 7)

7
Quick Start
While F/REAR BALANCE and L/R BAL-
ANCE usually should be in the “0” position,
the OVERALL GAIN knob controls the basic
volume. It can be adusted when the fifth
selector switch is turned so that only one
LED in its surrounding circle lights up. The
OVERALL GAIN serves to control mastering
devices.
With the func-
tion control in
the lower posi-
tion (orange
mode =
“GAIN/dB
MODE”)...
...this control
must be set to
“A” (only one
LED will be lit).
For processing
the signals this
control must be
set to “B”,
which is the
case when any
pair of LEDs
lights up.
Signals at the analog outputs (XLR-5):
Signals at the digital outputs:
left
1 3 2 4
right
channels
left
1 3 2 4
right
channels
yellow / red
end of SCHOEPS Y-adapter cable
end of SCHOEPS Y-adapter cable:
yellow / red
Processing and Recording simultane-
ously
If processing is to be done while recording,
connect the microphones as shown on
page 6. Then set the function control to the
GAIN/dB mode (see illustration in column 1
on this page). Finally, turn the REAR
SLOPE/Hz / MODE knob until a pair of
LEDs in its surrounding circle lights up.