SCHOEPS KFM 360 - Manual (Page 8)

Quick Start
+ phase color
channel pins at pin marking*
Output I: left front 2, 3 2 yellow
right front 4, 5 4 red
Output II: center 2, 3 2 yellow
LFE 4, 5 4 red
Output III: left surround 2, 3 2 yellow
right surround 4, 5 4 red
* with SCHOEPS Y-cable AKSU/2U (XLR-5 to 2x XLR-3)
Processed analog outputs:
Processed digital outputs:
channel
Output I: left front
right front
Output II: center
LFE
Output III: left surround
right surround
Note:
The position of the function control deter-
mines whether you are using the function
settings of the first (green) layer or the sec-
ond (red) layer. Only the settings in the cur-
rently selected layer will be changed.
The center channel is not active when the
“FRONT PANORAMA” is in the lowest posi-
tion (function control in “PATTERN SURR.”
position = green mode).
For lowest noise, the “Analogue Mic Gain”
switch on the rear side should be in the
upper position (+20 dB). The “+10 dB” posi-
tion is reserved for exceptionally high levels.
The indicated polar patterns are nominal
settings which will be precisely valid only if
the gains of all the record/playback channels
are carefully matched.
8