Warning caution warning warning, Installation step 1, Determine the header bracket location – Chamberlain 1215E FS2 User Manual

Page 16

Advertising
background image

16

INSTALLATION STEP 1

Determine the Header Bracket
Location

Installation procedures vary according to garage door
types. Follow the instructions which apply to your
door.

If your door is a canopy or dual-track style garage
door, a door arm conversion kit is REQUIRED.
Follow the installation instructions included with the
replacement door arm sectional.

SECTIONAL DOOR
AND ONE-PIECE DOOR WITH TRACK

1. Close the door and mark the inside vertical

centerline of the garage door.

2. Extend the line onto the header wall above the

door.

You can fasten the header bracket within 1.2 m
of the left or right of the door center only if a
torsion spring or center bearing plate is in the
way; or you can attach it to the ceiling (see
page 17) when clearance is minimal. (It may be
mounted on the wall upside down if necessary,
to gain approximately 1 cm.)

If you need to install the header bracket on a
38 mm board (on wall or ceiling), use lag screws
(not provided) to securely fasten the 38 mm board
to structural supports as shown here and on
page 17.

3. Open your door to the highest point of travel as

shown. Draw an intersecting horizontal line on the
header wall 5 cm above the high point. This height
will provide travel clearance for the top edge of the
door.

Proceed to Step 2, page 18.

To prevent possible SERIOUS INJURY or DEATH:
• Header bracket MUST be RIGIDLY fastened to

structural support on header wall or ceiling, otherwise
garage door might not reverse when required. DO NOT
install header bracket over drywall.

• Concrete anchors MUST be used if mounting header

bracket or 38 mm board into masonry.

• NEVER try to loosen, move or adjust garage door,

springs, cables, pulleys, brackets, or their hardware, all
of which are under EXTREME tension.

• ALWAYS call a trained door systems technician if

garage door binds, sticks, or is out of balance. An
unbalanced garage door might not reverse when
required.

Finished
Ceiling

Header
Wall

38 mm
Board

Structural
Supports

Vertical
Centerline of
Garage Door

WARNING

CAUTION

WARNING

WARNING

Header
Wall

Ceiling

SECTIONAL DOOR
WITH CURVED TRACK

Track

Highest Point
of Travel

Door

Header
Wall

Door

Track

Jamb
Hardware

Highest Point
of Travel

ONE-PIECE DOOR
WITH HORIZONTAL
TRACK & JAMB
HARDWARE

Highest Point
of Travel

Door

Track

Garage
Exterior

Track

Header
Wall

Highest Point
of Travel

Door

Track

CANOPY ONE-PIECE
DOOR WITH
VERTICAL TRACK

Header
Wall

ONE-PIECE DOOR
WITH HORIZONTAL &
VERTICAL TRACK

Advertising
This manual is related to the following products: