Memory detection and configuration, Boot error codes, 4 boot error codes – Compaq W4000 User Manual

Page 142

Advertising
background image

Technical Reference Guide

7.3.3 MEMORY DETECTION AND CONFIGURATION

This system uses the Serial Presence Detect (SPD) method of determining the installed DIMM
configuration. The BIOS communicates with an EEPROM on each DIMM through the SMBus to
obtain data on the following DIMM parameters:

♦ Presence
♦ Size
♦ Type
♦ Timing/CAS latency
♦ PC133 capability

NOTE: Refer to Chapter 3, “Processor/Memory Subsystem” for the SPD format and
DIMM data specific to this system.


The BIOS performs memory detection and configuration with the following steps:

1. Program the buffer strength control registers based on SPD data and the DIMM slots that are

populated.

2. Determine the common CAS latency that can be supported by the DIMMs.
3. Determine the memory size for each DIMM and program the GMCH accordingly.
4. Enable refresh
5. Determine if the memory configuration will allow for 133MHz memory operation and

program the memory clock and MCH (see note below)

NOTE: The presence of PC133-compliant DIMMS will be indicated by BIOS reading
75h from byte 9 and 64h or 85h from byte 126. For PC133 operation to occur the FSB of
the processor must be running at 133 MHz and all installed DIMMs must be
PC133-compliant and total no more than four “sides.” Refer to Chapter 3 for more details
on PC133 operation.

7.3.4 BOOT ERROR CODES

The BIOS provides visual and audible indications of a failed system boot by using the keyboard
LEDs and the system speaker. The error conditions are listed in the following table.
Table 7-2. Boot Error Codes

Table 7-2. Boot Error Codes

Visual [1]

Audible

Meaning

Num Lock LED blinks

1 short, 2 long beeps

System memory not present or incompatible.

Scroll Lock LED blinks

2 long, 1 short beeps

Hardware failure before graphics initialization.

Caps Lock LED blinks

1 long, 2 short beeps

Graphics controller not present or failed to
initialize.

Num, Caps, Scroll Lock LEDs

blink

1 long, 3 short beeps

ROM failure.

Num, Caps, Scroll Lock LEDs

blink in sequence

none

Network service mode

NOTE:

[1] Provided with PS/2 keyboard only.

Compaq Evo and Workstation Personal Computers

Featuring the Intel Pentium 4 Processor

Second Edition - January 2003

7-5

Advertising