Parallel interface, Standard parallel port mode – Compaq W4000 User Manual

Page 98

Advertising
background image

Technical Reference Guide

5.5 PARALLEL

INTERFACE


The legacy-light models include a parallel interface for connection to a peripheral device that has
a compatible interface, the most common being a printer. The parallel interface function is
integrated into theLPC47B277 I/O controller component and provides bi-directional 8-bit parallel
data transfers with a peripheral device. The parallel interface supports three main modes of
operation:

♦ Standard Parallel Port (SPP) mode
♦ Enhanced Parallel Port (EPP) mode
♦ Extended Capabilities Port (ECP) mode

These three modes (and their submodes) provide complete support as specified for an IEEE 1284
parallel port.

5.5.1 STANDARD PARALLEL PORT MODE

The Standard Parallel Port (SPP) mode uses software-based protocol and includes two sub-modes
of operation, compatible and extended, both of which can provide data transfers up to 150 KB/s.
In the compatible mode, CPU write data is simply presented on the eight data lines. A CPU read
of the parallel port yields the last data byte that was written.

The following steps define the standard procedure for communicating with a printing device:

1. The system checks the Printer Status register. If the Busy, Paper Out, or Printer Fault signals

are indicated as being active, the system either waits for a status change or generates an error
message.

2. The system sends a byte of data to the Printer Data register, then pulses the printer STROBE

signal (through the Printer Control register) for at least 500 ns.

3. The system then monitors the Printer Status register for acknowledgment of the data byte

before sending the next byte.


In extended mode, a direction control bit (CTR 37Ah, bit <5>) controls the latching of output data
while allowing a CPU read to fetch data present on the data lines, thereby providing bi-directional
parallel transfers to occur.

The SPP mode uses three registers for operation: the Data register (DTR), the Status register
(STR) and the Control register (CTR). Address decoding in SPP mode includes address lines A0
and A1.


Compaq Evo and Workstation Personal Computers

Featuring the Intel Pentium 4 Processor

Second Edition - January 2003

5-11

Advertising