SONIQ QV290 - Manual (Page 10)

８
status. In this status, you can press “MENU” button to stop the searching.
At the end of automatic searching, the Program No. will jump automatically to the
Program No.0, and set the picture state as "STANDARD", the volume output value will be
set as "15".
2 Program presetting (semi-automatic searching)
If the automatic searching function cannot fine the desired channel, please use the
semi-automatic searching function. You can also first press the “MENU” to the “PRESET”
menu, then press “P+/P-“button to point the arrow to “PRESET”, Select “SEARCH”,then
use “V+/V-”button will start searching channel .Select “V+” button will start searching to
higher channel numbers, and pressing“V-”button for searching to lower channel. Repeat
this step until you fine your desired channel.
In semi-automatic searching will stop when a program is found.
3 Fine tune
You can first use “P+/P-” or direct Program No. buttons to select the Program No. for
fine tuning press “MENU” button to display the “PRESET” menu ,then press “P+P-”
button to point the arrow to “POSITION”, then use the “V+/V-” button to adjust the
Program No. to your desired one.
Select “FINE”, pressing “V+” button will make the fine tune to high end from the
current channel, and pressing “V-” button will make the fine tune to high end, unit the best
sound and picture are obtained.
During fine tune , the “V+” or “V-” button must be pressed all the time for fine tune to
respective directions, and releasing the “V+” or “V-” button can stop the fine tune. After
fine tune, the set value will put into memory automatically.
Fine tune is not necessary under normal conditions. In areas with poor transmission
signal, adjustment may be fine tune.
TV Operation
PRESET
POSITION 2
MEMORY NO
FINE
SEARCH
AUTO —SEARCH
l l l l l l l l l l l l . . . . . . . . . .60
CH+/CH- : SELECT
VOL+/VOL- : ADJUST