Notice to installer – SoundOff Signal 200 Series Siren with Connectors User Manual
Page 5
IMPORTANT INFORMATION:
Warning devices are strictly regulated and governed by Federal, State and Municipal ordinances. These devices shall be used ONLY on approved vehicles. It is the sole responsibility of the user of these devices to ensure compliance.
To review our Limited Warranty Statement & Return Policy for this or any SoundOff Signal product, visit our website at
www.soundoffsignal.com/sales-support.
If you have questions regarding this product, contact
Technical Services, Monday - Friday, 8 a.m. to 5 p.m. at 1.800338.7337 (press #4 to skip the automated message).
Questions or comments that do not require immediate attention may be emailed to
SUPERIOR CUSTOMER RELATIONSHIPS. SMARTLY DESIGNED LIGHTING & ELECTRONIC SOLUTIONS.
For 200 Series Sirens the speaker must be
electrically isolated from the vehicle’s chas-
sis ground.
NOTICE TO INSTALLER:
When installing your speaker, be sure to use
the supplied electrical isolation hardware kit
as shown left.
1. Use a .375 drill bit to drill a hole in the
speaker bracket to allow room for the shoul-
der washer if needed.
2. Place shoulder washers between the
speaker and the speaker bracket
3. Place flat washer on outside of speaker
bracket and use the screws supplied with
your speaker to screw together.
SPEAKER
SPEAKER BRACKET
FLAT WASHER
SHOULDER WASHER
ETSA2ØØR(x) 6.13