Stealth Cam STC-I530IR Nomad-IR - Manual (Page 24)

STC-I530IR
www.stealthcam.net Toll Free 877-269-8490
24
Using the camera in PIR detection mode:

Mount the camera to tree or other sturdy object using either a
tree screw (optional accessory), or supplied mounting strap
(You may refer to the mounting suggestions section in this
manual)

Open the front housing and move the switch to the ON position.
At this point, you have 30 seconds to make any program
adjustments.
 After 30 seconds the camera’s green LED light will begin
blinking and enter count down mode. This is your indication to
leave the coverage area within one minute.

After one minute, the camera will enter either image burst
mode or adjustable video mode based on your programming.
The camera will then time out between 1 ~ 59 minutes,
depending on your setting.
 The time between motion detection and the camera taking
pictures may vary due to lighting conditions, program settings,
and battery power level.
 The IR Emitter will only activate in low light conditions.