SWIT Electronics S-4913R - Manual (Page 8)

5. Trouble-Shooting
If the receiver failed to output video correctly, and OSD displayed as Pic (5) or Pic (6), please find the solution
from following chart:
Pic (5) Pic (6)
OSD Display Possible Causes Solution
The transmitter S-4913T is powered off
Check the power supply of the
transmitter.
Antenna unconnected of either
transmitter or receiver
Fix on the antennas to both transmitter
and receiver, and check the connection
conditions.
The transmission distance is out of
effective range. Try the wireless transmission at a closer
distance.
Searching
There’re obstacles between transmitter
and receiver, and blocked the signal
transmission.
Try to get rid of the obstacles, or operate
at a closer transmission distance
Connected to TX1,
Please Check
Video Source
There’s no recognized video input at
transmitter side.
Check the HDMI video source and cable
connections of S-4913T transmitter.
(See the supported HDMI format at 6.
Specifications)
The wireless transmission is disturbed by
environment, such as other electronic
devices in the same location.
Wait 60 seconds or restart the transmitter
and receiver
Please wait, this
action may take up
to 60Sec
The transmission distance is out of
effective range. Try the wireless transmission at a closer
distance.