Trail Master Suspension TM413N FORD SUPER DUTY F-350 4WD DIESEL SUSPENSION LIFT KIT - Manual (Page 9)

TM411N, TM412N,
TM413N, TM414N
Revised
7.11.13
9
Save the factory isolators for re-use.
NOTE: Be sure to support the axle
while the springs and shocks are removed.
35. Remove the front brake line retaining clip.
Separate the brake line from the bracket.
Save the OE clip for reinstallation. See IL-
LUSTRATION 7.
36. Loosen the OE hard line ferrule, just
enough, to be able to rotate it 180 degrees so
the rubber line is facing toward the bottom
of the vehicle and retighten. See ILLUS-
TRATION 7.
37. Unbolt and remove the OE brake line
bracket from the frame. Save the OE bolt
for reinstallation.
38. Install the new brake line drop bracket (90-
7722 Drvr and 90-7723 Pass) to the original
hole in the frame rail using the previously
removed OE bolt. See ILLUSTRATION 7.
39. Secure the brake line to the new bracket us-
ing the previously removed OE clip. See
ILLUSTRATION 7.
40. Remove the factory front bump stop from
the bump stop mounting cup. Pliers and a
back and forth rocking motion will assist in
removal of the bump stop.
41. On the driver side, unbolt the bump stop
mounting cup and drill out the factory hole
in the frame and bump stop mounting cup to
7/16”.
42. On the passenger side, unbolt the bump stop
mounting cup. Measure in toward the en-
gine 5/8” from the center of the factory
bump stop hole in the frame. Center punch
and drill and the new hole 7/16” in the
frame. Drill out the bump stop mounting
cup to 7/16”.
43. Use the supplied 7/16” X 6 1/2” bolt and
hardware to bolt the bump stop drop (91-
2511) and mounting cup to the bump stop
hole in frame. See ILLUSTRATION 8.
NOTE: Be sure to fit the tab from the
mounting cup into the hole in the drop.
44. Reinstall the previously removed factory
bump stop into the mounting cup on the new
bump stop drop. See ILLUSTRATION 8.
Illustration 9
Sway Bar Install
Sway Bar
Front of Vehicle
OE Studs OE Nut
OE Studs
Sway Bar Drop
Bracket 82-7029 pass
OE Nut
OE Nut
OE Nut
7/16” X 1
3/4” Bolt
Sway Bar
Drop
Bracket
82-7026
drvr
OE Sway
Bar End
Link
12mm X
65mm
Bolt
Steering
Stabilizer
OE Sway
Bar End
Link
7/16” X 1
3/4” Bolt
Sway Bar
Spacer Plate
82-3822
Steering Stabilizer
Mounting Bracket
82-3823