Trail Master Suspension TM103N CHEVEROLET SILVERADO 4WD/2WD 6 SUSPENSION LIFT KIT - Manual (Page 10)

10
TM103N
Revised
1.28.14
53. Secure the lower strut cross pin to the lower A-
arm using the OE bolts. Torque the bolts ac-
cording to the manufacturers specifications.
54. Torque the upper ball joint nut to 37 Ft./lbs.
55. Be sure to re-clip the previously removed upper
strut mount wiring away from any moving parts,
steering shaft or exhaust manifolds.
56. Work on one side of the vehicle at a time.
57. Torque all the differential, upper crossmember
bolts and coil over hardware according to the
torque chart on page
3 or to factory specifica-
tions. DO NOT torque the lower A-arm until
the vehicle is on the ground.
58. Unbolt the rubber brake line bracket from the
upper coil bucket. Discard the OE bolt.
59. Unclip the OE metal brake lines from the frame
clips and carefully bend to provide enough slack
in the line for it’s new position.
NOTE: Be sure that the metal lines do not
rub or contact anything.
60. Install the ABS line relocation bracket (90-
7876) studs, from the bottom, into the existing
holes in the rear of the upper control arm pocket.
Install the brake line relocation bracket (90-7734
drvr and 90-7735 pass) to the ABS relocation
bracket mounting studs. Secure using the sup-
plied 1/4” washers and nuts. See ILLUSTRA-
TION 13.
61. Bolt the brake line to the previously installed
brake line relocation bracket (90-7734 drvr and
90-7735 pass) using the supplied 5/16” X 1”
bolt. See ILLUSTRATION 13.
62. Reinstall the rotors and brake calipers to the new
knuckle using the previously removed OE bolts.
Be sure to use thread locker on the caliper
bracket mounting bolts. Torque to factory
specifications.
NOTE: It may be necessary to carefully
bend the caliper banjo fitting slightly up to pro-
vide adequate slack for the brake line. Be very
careful not to damage the banjo fitting or
brake line in any way. Check tightness of
82-2614
Coil
Spacer
OE
Hardware
7/16”
Hardware
OE Strut
Be Sure the
Location
Tab is
Facing Out
Installed View
Illustration 12
Strut Spacer Install