Trail Master Suspension TM103N CHEVEROLET SILVERADO 4WD/2WD 6 SUSPENSION LIFT KIT - Manual (Page 12)

12
TM103N
Revised
1.28.14
torque chart on page 3 .
75. On both sides of the vehicle, check the routing
of the brake lines and the ABS wire harnesses.
There must be no pinching, rubbing, or
stretching of either component. Use zip ties to
secure these items to the steering components.
At full droop, cycle the steering from lock to
lock while observing the reaction of these
components. Reposition them if needed.
76. On some vehicles the driver’s side OE wire har-
ness that connects to the ABS wire may be
shorter, from the factory, than others. If the line
needs to be extended GM #19149296
(ACD#PT2232) can be installed into the chassis
wire harness. Check the harness at full droop, if
it is too tight it may cause the ABS light to acti-
vate.
77. With the front wheels installed cycle the steer-
ing from lock to lock to check to make sure the
front wheels have enough clearance in the
wheel well. If the wheel contacts the front or
rear of the wheel well some trimming will be
necessary. Check the caliper banjo fitting to
ensure the line has the proper amount of slack.
NOTE: Remove OE rotor/drum retaining
clips from wheel studs before installing the
wheels.
78. Lower the vehicle to the ground. Torque the
lug nuts according to the wheel manufacturers
recommendations.
79. With the truck on the ground torque the lower
A-arm bolts according to the torque chart on
page
3 .
80. Center the steering wheel and lock it in place.
Set the toe by adjusting the tie rod ends prop-
erly.
IMPORTANT!: If the steering wheel and
front wheels are not centered properly it will
trigger the anti-lock brake and traction control
warning lights.
81. Lock the outer tie rod ends by tightening the
16mm jam nuts.
82. Recheck all hardware for proper installation
and torque at this time.
IMPORTANT! BE SURE TO BRING
THE VEHICLE IMMEDIATELY TO A REPU-
TABLE ALIGNMENT SHOP TO BE ALIGNED!
Illustration 14
Sway Bar Drop Bracket
Install
Sway Bar Drop
Bracket 82-
3632 drvr and
82-3635 pass
10mm X 30mm
Bolts
For 2007-2009 models:
Use the 7/16” X 2 1/2”
bolts
For 2010-2011 models:
Use the OE bolts and
10mm washers and
10mm nuts
(4) 7/16” nut
or 10mm nut