Cabletron Systems 9F106-01 - Manual (Page 15)

Installing the MMAC-Plus Module
2-6
Installing an FPIM
The 9F106-01 module is shipped without FPIMs. To install an FPIM, follow the
procedure below:
1. Remove the module if it is installed in the MMAC-Plus chassis.
2. Remove the blank front cover over the FPIM slot.
3. Install the FPIM as shown in Figure 2-4. Ensure that the rear connector is
seated firmly before tightening the two mounting screws.
Figure 2-4. Installing an FPIM