3t.03 setting up automation or machine torch – Tweco A80-A120 CutMaster User Manual
Page 28
CUTMASTER A80, A120
INSTALLATION Manual 0-5119
3T-2
3T.03 Setting Up Automation or
Machine Torch
NOTE
An adapter is required to be installed in the power
supply if converting a hand torch system to oper-
ate a machine or automation torch.
WARNING
Disconnect primary power at the source before
disassembling the torch or torch leads.
The Automation and Machine torch include a position-
ing tube with rack and pinch block assembly.
1. Mount the torch assembly on the cutting table.
2. To obtain a clean vertical cut, use a square to
align the torch perpendicular to the surface of
the workpiece.
A-02585
Workpiece
Square
Pinch Block
Assembly
Automated and Machine Torch Set - Up
3. The proper torch parts (shield cup, tip, start
cartridge, and electrode) must be installed for
the type of operation. Refer to Section 4T.08,
Torch Parts Selection for details.