Tweco SC10 - Manual (Page 19)

Manual 0-2479 3-3 INSTALLATION PROCEDURES
A-00698
J7
PLA SM A O N
ARC VOLTS RE MO TE ST AN DO FF CO NT RO L
T.H .C. A CTIV E
PIER CE HT (i nche s)
0.1 0.3
0.4
0.5
0.2
END OF C UT RET RAC T (% )
0
25
75
100
UP
DN
TOR CH TORCH
MOD E MODE
LIF TE R LIFTER
SPEE
D SPEED
PIER CE DEL AY (s ec)
0.5
1
2 3
0.75 0.25
0.1
AU TO HT
FIN
D HT
HI LO
Standoff Control
Assembly
OU TPU T A MP S
PLASMA PLASMA
ENABLE ENABLE ON
STA RT
REM OTE PO WE R S UPP LY C ON TRO L
SD (% )
25
75
100
50
TRAVEL TRAVEL SPEED SPEED
125 + IPM 0-125
IPM RU N PU RG E SET
J5
Remote Control
Assembly
Figure 3-4 J7 and J5 Locations
9. Place the top unit on top of the bottom unit, feed-
ing the ribbon cable up through the bottom of the
top unit.
10. On the top unit, connect the other end of the rib-
bon jumper cable into one of the following:
• Standoff Control J7 if top unit
or
• Remote Control J5 if top unit
11. Secure the two units together with four #6-32x1/2
inch thread forming screws (supplied) inserted at
the front and rear panels (two screws each) in the
holes provided.
PLA SM A O N
AR C V OL TS
RE MO TE ST AN DO FF CO NT RO L
T.H .C. A CTIV E
PIER CE HT (in che s)
0.1 0.3
0.4
0.5
0.2
EN D O F C UT RET RA CT (% )
0
25
75
100
UP
DN
TOR CH TORCH
MO DE MODE
LIFT ER LIFTER
SPE ED SPEED
PIER CE DELA Y (se c)
0.5
1
2 3
0.75 0.25
0.1
AU TO HT
FIN D HT
HI
LO A-00689
Screw
Screw
Cover
Figure 3-3 Cover Removal
4. Remove the top enclosure cover by lifting straight
up at the rear of the cover and pulling it towards
the rear of the unit. The front edge of the cover
fits under a lip on the front panel assembly.
5. Turn the unit over.
6. Repeat Steps 3 and 4 for the bottom enclosure
cover.
7. On the bottom unit remove the two cover mount-
ing screws on the top of the unit and remove the
top enclosure cover as in Step 4.
8. Depending on which unit is to be the bottom unit,
install the ribbon jumper cable (supplied) into one
of the following:
• Standoff Control J7 if bottom unit
or
• Remote Control J5 if bottom unit