Tweco 12mm Cutmaster - Manual (Page 3)

!
WARNINGS
Read and understand this entire Operating Manual and your employer’s safety practices before installing,
operating, or servicing the equipment.
While the information contained in this Manual represents the Manufacturer's best judgement, the
Manufacturer assumes no liability for its use.
Plasma Cutting Power Source
CutMaster™ 10mm Plant - Part Number 1-4730-6
Cutmaster™ 12mm Plant - Part Number 1-4200-6
SL60 Torch™
Operating Manual Number 0-5197AE
Published by:
Thermal Dynamics Corporation
82 Benning Street
West Lebanon, New Hampshire, USA 03784
(603) 298-5711
www.thermal dynamics.com
Copyright 2011, 2012 by
Victor Technologies
All rights reserved.
Reproduction of this work, in whole or in part, without written permission of the publisher is
prohibited.
The publisher does not assume and hereby disclaims any liability to any party for any loss or
damage caused by any error or omission in this Manual, whether such error results from negli-
gence, accident, or any other cause.
Publication Date: July 1, 2011
Revision AE Date: September 3, 2012
Record the following information for Warranty purposes:
Where Purchased:_______________________________ __________________
Purchase Date:__________________________________ __________________
Power Source Serial #:___________________________ ___________________
Torch Serial #:___________________________________ _________________
i