Creek Audio Wyndsor - Manual (Page 4)

Overview
The Creek Wyndsor turntable shipped
from the factory without arm - its
versatility allows it to be fitted with the
arm of your choice.
For photographic purposes we have
chosen to use the Rega RB300 and
Goldring MM cartridge.
The turntable is mounted on the Creek
AR4 rack, which not only supports the
turntable but also isolates the vibrations
that cause feedback.
The two products complement each other as similar parts are used on both. The
adjustable feet and damping rings are identical.
Assembly Instructions
To avoid marking the acrylic parts, please be sure to complete the assembly wearing
the white gloves provided.
The black acrylic base is already fitted with the three adjustable
silver feet and spikes. Be very careful not to damage anything with
the pointed spikes while assembling the table.
Remove the base from the plastic bag and place it on the surface
where you intend to use it.
Take the bearing and separate the two halves by unscrewing the
large bolt at one end. There is oil covering the ceramic spindle -
take care not to allow the oil to get on the other parts. If by chance it
does, then simply wipe it clean.
Place the bottom section of the bearing through the centre hole in the black base and
then tighten the bolt and cup to the underside to hold it tightly in place. It should be a
tight fit so some effort may be required to force it into place. Use the Allen key provided
to tighten the bolt, just enough to stop it from coming loose. Do not over-tighten it.
Add a small amount of oil to the inside of the top section of the bearing and place it onto
the ceramic shaft.
Page Four