Creek Audio Wyndsor - Manual (Page 7)

Assembly Instructions Cont’d.
P l a c e t h e L P 1 m o t o r s p e e d
controller on a shelf within range of
the motor cable.
Plug the 4-pin power plug into the
back of the LP1 speed controller, in
the appropriate socket.
Once it is plugged in, tighten the
locking ring around it.
Plug the appropriate mains plug
onto the OBH-Uni power supply
adaptor for your country of use.
The Universal power supply (OBH-Uni) provides 24V DC at 625 mA - 15 Watts in total. It
can operate in any region, with mains voltages ranging from 85 - 265V AC/50 Hz - 60 Hz
Plug the 2.3mm DC jack plug into the back of the LP1 speed controller.
The switch on the motor can over-ride the speed controller, so it should normally be in
the ON position (1) and then the power can be applied from the power switch on the left
hand side of the speed controller.
Select either 45 or 33.3 RPM from the buttons on the front of the speed controller. Use
the stroboscope to set the absolute speed.
Place it on the platter and run the turntable at the desired speed. Adjust the appropriate
control knob on the front panel to set the speed.
The lines on the stroboscope should appear to stop moving when the right speed has
been reached.
When playing a record, place the heavy
clamp on top of the spindle to flatten the
record and stop resonances or vibration from
affecting the performance.
It will be necessary to plug the RCA plugs
from the tone arm into an appropriate
amplifier fitted with a Phono pre-amp, set for
either MM or MC cartridge matching.
Creek Audio manufactures both moving magnet
and moving coil phono pre-amplifiers.
Page Seven