Valco Baby Twin Tri-mode Toddler Seat - Manual (Page 2)

TO INsTALL yOUR TwIN
TRI-MODE TODDLER sEAT:
(THE EAsy wAy!)
FIGURE A
1. Before you begin to install the toddler
seat make sure to remove the bumper bar
or nylon plugs from the housing on the
stroller frame.
To do so: From the underside of the nylon
housing, feel the side of the nylon housing
that sits below the frame at each side of the
stroller (the place where the bumper bar
connects to the stroller).
2. Locate the center release “button.” (1)
3. Press the release button inward while
simultaneously pushing upward on the bar
or plug.
4. Repeat for the other side.
note: to aVoid FinGer entraPMents,
the nylon PluGs Must be
retained and installed when the
buMPer bar or toddler seat is not
in use.
FiGure b
5. remove the toddler seat from the box.
Your toddler seat will come folded flat and
compact.
FiGure C
6. Open the seat up by pulling the seat
back away from the ‘U’ shaped metal bar.
A
C
B
1
1
Remove Bumper Bar or Plugs
Bumper Bar
Nylon Plug
press
1