Valco Baby Hitch Hiker - Manual (Page 3)

8. Holding the strap firmly locked
into the housing, slide the
frame clamp over the strap
until the strap exits through
the side slot and the thread
through the exit hole.
9. If you need to turn the length
adjuster so the rocker switch
is on the top, press down on
the rocker switch and pull the
adjuster all the way back
toward you.
10. Turn it over and press down on
the rocker switch to re-insert
on the arm housing.
6. Secure with the knob and
tighten.
7. Repeat this procedure for the
opposite side.
15. Attach the arms to the
stroller by placing the
securing rivet over the channel
in the frame clamp.
16. Pull the spring loaded cover
back to open the channel.
17. Insert the securing rivet firmly
into the channel and release
the cover.
18. Repeat for the other side.
11. Insert each of the arms into
the board channel on either
side.
12. Move the board left or right
until it sits centred behind the
stroller. Lock the position by
tightening the two screws on
the underside of the board.
13. Lock the position by tightening
the two screws on the
underside of the board.
14. Ensure that the board is as
parallel as possible to the
ground by turning the arm
adjusters. To do this,
simultaneously press the
buttons and turn the board
until it is horizontal to the
ground.
19. Adjust the distance of the
board from the stroller by
depressing the rocker switch
and moving the arms in the
desired direction.