Warnings, Your child’s safety is your responsibility – Valco Baby Hitch Hiker User Manual

Page 4

Advertising
background image

























































© Copyright VE 2004

WARNINGS

Your child’s safety is your responsibility ………

Be sure that all clamps and buckles are securely fixed into place before use.

Moving parts may be lubricated with silicone spray – DO NOT USE OIL.

The maximum weight of the child for which this product is intended is up to 30 kg’s.
Recommended from approximately 2 years plus.

Your child’s feet should be completely standing on the dimpled/non slip part of the
HITCHHIKER RIDE ON STAND.

Your child should never be left unattended while on the HITCHHIKER RIDE ON STAND.

Your children should never be left unattended. Children in the stroller must always wear a

safety harness, correctly fitted and adjusted, at all times.

Always keep your hand on the pram handle when your child is using the HITCHHIKER RIDE
ON STAND.

The parking brake of your pram or stroller should not be used while a child is on the
HITCHHIKER RIDE ON STAND.

Check all parts before use for breakage or fatigue. Discontinue use immediately if any part is

found to be damaged or broken.

Do not carry additional children.

Make sure that any part of the child’s body is clear of all moving parts before making any
adjustments.

Your VALCO product is intended for domestic use only. It is not intended for commercial use.

Never carry your HITCHHIKER RIDE ON STAND with a child on it.

This product is intended for domestic use only. It is not intended for commercial use.

AXLES ARE BEST LUBRICATED WITH GREASE OR PETROLEUM JELLY. MOVING PARTS ARE
BEST LUBRICATED WITH SILICONE BASED PRODUCTS. DO NOT USE OIL BASED
PRODUCTS.

Examples of the Hitchhiker on different

product types

20. Attach the strap to your

stroller handle by looping it over
the bar and securing by
threading it through the sewn
loop.

21. You can conveniently “fold” your

hitchhiker out of the way by
lifting it and securing it to the
strap by inserting the strap
buckle through the slot in the
board.

22. Adjust the strap length using

the slider buckle. Ensure the
strap is tight, lifting the entire
unit as much “out of the way” as
possible.

23. To release, press the buckle

tongue on the underside of the
stand, ease the buckle out of
the board and gently lower the
unit to the ground.

www.valco.com.au

In Australia/NZ

www.valcobaby.com

In North America

Advertising