Valco Baby Twin Latitude Maxi Cosi Car Seat Adaptor - Manual (Page 4)

In North America only
www.valcobaby.com
1 800 610 7850
FIgURE I
19. Once strap is tightly wrapped, pull the Female
clip over the front hook
20. Place Male clip under the front bumper bar
21. Insert the Male clip into the Female clip and
buckle
22. Adjust strap to tighten.
FIgURE J
15. Locate a Male/Female straps previously
attached to side of stroller.
16. slip strap through the car seat belt hooks on
the side of the car seat.
17. Repeat with the other strap.
18. Insert Male clip into its Female counterpart
and buckle.
19. Adjust straps to tighten around car seat.
TO REMOVE yOUR CAR sEAT:
20. Reverse the steps outlined in Figure I and lift
out the car seat.
I
wARNINgs
•Always follow car seat manufacturer’s instructions when using the car seat.
•Be sure to check that all straps are securely fixed and in place before use.
• Check all parts for breakage or fatigue before use. Discontinue immediately if any part
is found to be damaged or broken.
• NEVER leave any child unattended at any time.
• This product is intended for use in North America only. It is not intended for use in
Australia.
• This product is intended for domestic use only. It is not intended for commercial use.
J
1
2