Wildview STC-TGL-X35IR - Manual (Page 22)

STC-TGLX35IR
www.wildviewcam.com Toll Free 888-304-6125
22
screen shows “ESC” then press [SET] again to exit.
d. This will only delete the last image saved in the memory.
o Delete All pictures:
a. Press [SET] button to enter delete setting. Display will
show “ESC”
b. Press [UP] or [DN] to select d-ALL (delete all)
c. Press [SET] to delete all images. The display will show
“dONE” and will exit to count down mode automatically.
o Format:
a. Press [SET] button to enter delete setting. Display will
show “ESC”
b. Press [UP] or [DN] to select Ft (format)
c.
Press [SET] to confirm. The display will show “dONE” and
exit to count down mode automatically.
o ESC: To exit delete setting.
2. Simply remove the batteries from the battery compartment. This
will delete the image stored in the internal SDRAM memory only. If
you are using an SD card as your storage device, you must delete
images by following the step above.