Wildview STC-TGL-X8IR - Manual (Page 2)

www.wildviewcam.com
Toll Free 888‐304‐6125
5
Open view image with major parts indication
www.wildviewcam.com
Toll Free 888‐304‐6125
6
CAMERA KIT CONTENT
• Model TGLX8IR Digital Scouting Camera
• User manual
• Strap
www.wildviewcam.com
Toll Free 888‐304‐6125
7
GENERAL INFORMATION
Special Care Instructions
• Operating Environment: 14 to 104 deg F (‐10 to 40 deg C). 20‐85%
relative humidity, non‐condensing.
• The camera is designed to be weather resistant. Never attempt to
immerse the unit in water or any other liquid. This will damage the unit
and void the warranty.
• Use a soft lens cloth for cleaning lens. Avoid touching lens with fingers.
• Remove dirt or stains with a soft cloth dampened with water or neutral
detergent. Keep your camera in a dry and cool dust‐free environment or
container when it is NOT used.
• Take the batteries out, when camera is NOT to be used over an extended
period of time.
• Avoid dropping your camera on to a hard surface.
• Do not disassemble your camera.
• Do not mix new and old batteries.
• Do not open the camera for unauthorized service. This could cause
serious damage to the unit and WILL void the warranty.
• When camera is turned off, if there is any residual power left in the
camera, it will take an extra picture to discharge the remaining power in
the camera. Under low lighting conditions, the flash will go off.
NOTE: This camera is a precision electronic device. Do not attempt to service
this camera yourself, as opening or removing covers may expose you to
dangerous voltage points or other risks.
www.wildviewcam.com
Toll Free 888‐304‐6125
8
BATTERY AND MEMORY INSTALLATION
Your Wildview Digital Scouting Camera is designed to operate using two
different types of battery power options.
Batteries “C” cell
The internal battery compartment accepts 4 “C” cell batteries. Be sure to use
high quality brand name alkaline batteries. Install batteries with correct
polarity (+/‐) as noted inside the battery compartment.
12V Lead Acid External Battery
The camera is equipped with an external power jack designed to accept a
barrel plug cable that attaches to a sealed lead acid battery. (Sold separately).
This will enhance the camera’s field life. Battery cable and complete 12V
Lead Acid battery kits are available wherever Wildview scouting cameras are
sold, or call toll free 888‐304‐6125. Only Wildview external battery
accessories are recommended.
1. Make sure camera is in the OFF position.
2. Insert the external battery barrel plug into the DC 12V jack on the bottom
of camera housing.
WARNING: Do not use different Voltage lead acid battery other than the
one specified in this section. Doing so will damage the camera and will
void the warranty.
WARNING: ALWAYS have the camera in the OFF position when installing
or removing batteries and memory card. Removing batteries or memory
card while the camera is ON may damage the camera.