Winchester Repeating Arms 94 Top Tang Safety (Historic Manual) - Manual (Page 18)

tip of the first cartridge until all but the rim has entered
the loading port (Figure 10).
2. Then, insert the next cartridge in the same manner,
pushing the preceding cartridge into the magazine.
3. Repeat this procedure with each cartridge, but push the
last cartridge past the end of the spring cover, allowing
the cover to snap closed (Figure 11). Do not exceed the
recommended capacity of the magazine.
BEFORE LOADING, ALWAYS MAKE SURE TO
ALWAYS PLACE THE MANUAL HAMMER
STOP/SAFETY IN THE "ON" POSITION, AND
THE HAMMER INTO THE REBOUND POSITION.
CAUTION: ALWAYS MAKE SURE THE
CARTRIDGES ARE OF THE PROPER CALIBER
FOR YOUR RIFLE. CHECK THE AMMUNITION
DESIGNATION ON THE BARREL. FAILURE TO
FOLLOW THIS INSTRUCTION CAN RESULT
IN SEVERE DAMAGE TO YOUR GUN AND
POSSIBLE SERIOUS INJURY TO YOURSELF
OR OTHERS.
U NLOADING P ROCEDURES
Fully unloading your rifle when storing your rifle or in
other appropriate situations is essential to safe gun
handling.
BEFORE UNLOADING, CHECK TO ASSURE
THAT THE MANUAL HAMMER STOP/SAFETY
IS IN THE "ON" POSITION (SAFE) BY MOVING
IT REARWARD WITH YOUR THUMB,
18
FIGURE 11
Push the last cartridge fully in,
allowing the cover to close
Cover closed
FIGURE 10
Insert the cartridge
to the rim (no farther)
02-227-WFA_94 OM Revised 7/17/03 9:33 AM Page 18