Winchester Repeating Arms 9422 (Historic Manual) - Manual (Page 11)

11
U.S. Repeating Arms Co. can assume no responsibility
for incidents which occur through use of cartridges of
nonstandard dimension or those developing pressures in
excess of SAAMI (Sporting Arms and Ammunition
Manufacturer’s Institute) established standards.
Winchester ammunition is always an excellent choice
for your new Winchester rifle, delivering the unmatched
performance and dependability you want.
DISCHARGING FIREARMS IN POORLY
VENTILATED AREAS, CLEANING FIREARMS,
OR HANDLING AMMUNITION MAY RESULT
IN EXPOSURE TO LEAD AND OTHER
SUBSTANCES KNOWN TO CAUSE BIRTH
DEFECTS, REPRODUCTIVE HARM AND
OTHER SERIOUS PHYSICAL INJURY.
HAVE ADEQUATE VENTILATION AT ALL
TIMES. WASH HANDS THOROUGHLY
AFTER EXPOSURE.
F ULL DISASSEMBLY / T AKEDOWN
Knowing how to easily take down your Model 9422 or
Model 9417 is important for cleaning and maintenance.
TO ENSURE RIFLE IS UNLOADED, OPEN
ACTION AND CAREFULLY CHECK CHAMBER
AND MAGAZINE TUBE FOR AMMUNITION.
D ISASSEMBLY —
1. Unscrew and remove takedown screw on left side of
receiver (Figure 4).
2. Separate the gun into two halves by pulling the butt
stock downward to the rear (Figure 5).
3. The bolt slide may now be removed by sliding rearward
out of receiver (Figure 6). Use care to prevent the cam pin
from dropping free of the bolt.
4. Bolt and bolt slide may now be separated (Figure 7).
Your Model 9417 or Model 9422 will now be in these
pieces:
(Figure 8):
• Barrel/forearm half
• Buttstock half
• Breech bolt
• Bolt slide
• Cam pin
• Magazine tube
• Takedown screw
R EASSEMBLY —
1. Assemble bolt and bolt slide, keeping the cam pin
centered (Figure 9).
2. Insert the assembly into the receiver from rear, pushing
forward until it locks (Figure 10).
02-228-WFA_M9417/22 OM 7/16/03 1:58 PM Page 11