Winchester Repeating Arms 9422 (Historic Manual) - Manual (Page 9)

The Winchester Model 9422 and Model 9417 are also
shown disassembled to the extent necessary in order to
follow instructions contained in this book (Figure 9 later
in this manual). Throughout this manual the “action”
refers to the mechanism of this rifle which loads and
secures the cartridges in the chamber.
S ERIAL N UMBER
The serial number is located in two places on your Model
9422 or Model 9417: one on each half when disassembled
(Figure 3). One is on the bottom of the forward
receiver/frame assembly (barrel half of the rifle) toward
the front. The other is just rearward of the first one, on
the rear receiver/frame assembly (buttstock half of the
rifle). Record the serial number at the front of this book
for future reference.
9
Extractor Right
Upper
Extractor Left
Ejector
Extractor
Right
Lower
Bolt Face
Carrier Pawl
Firing Pin
This Figure is to acquaint you with the Model 9422’s
and 9417’s breech bolt terminology. Do not attempt to
disassemble the breech bolt.
Breech Bolt Locking
Surface
Bolt Cam
Pin
Bolt Slide
Firing Pin Striker
The hammer strikes the rear of
the firing pin striker, which in
turn strikes the firing pin.
FIGURE 2B
FIGURE 2C
Serial Number.
Record it for future reference.
FIGURE 3
02-228-WFA_M9417/22 OM 7/16/03 1:58 PM Page 9