Winchester Repeating Arms 9422 (Historic Manual) - Manual (Page 12)

10
Your Model 9422 will now be in these pieces:
(see Figure 8):
R EASSEMBLY —
1. Assemble bolt and bolt slide, keeping cam pin centered
(see Figure 9).
2. Insert assembly into the receiver from rear, pushing for-
ward until it locks (see Figure 10).
3. Pull hammer back to full-cock position and close finger
lever.
Center the cam pin
in the hole
Insert the cam pin into the hole
in the breech bolt
Cam pin
Barrel/Forearm
half
Buttstock half
Bolt slide
Magazine tube
Breech bolt
Takedown screw
FIGURE 8
FIGURE 9
Make sure the breech bolt
and bolt slide fit into the rails
in the receiver
FIGURE 10
• Barrel/forearm half
• Buttstock half
• Breech bolt
• Bolt slide • Cam pin
• Magazine tube
• Takedown screw