Winchester Repeating Arms Super X2 Practical Supplement (Historic Manual) - Manual (Page 2)

Winchester trademarks licensed from Olin Corporation.
5. Insert the forward magazine sleeve onto the magazine tube,
flanged end first. This is the end with the noticeable flange and a
rectangular protrusion coming from the flange.
6. Position the protrusion downward, in relation to the barrel,
where it contacts the front of the forearm. It will drop into a
matching recess in the front of the forearm (See Figure 2).
7. With the forward magazine sleeve in place, replace the magazine
cap. The barrel and gas system are now fully reassembled.
S PECIAL F OLDING S IGHT /C ANTILEVER S YSTEM
The Super X2 Practical has a cantilever rear sight rail for mounting
optical, red dot or similar type sights. At the front of the can-
tilever is a fold-down sight (See Figure 3). With the rear sight in
the “up” position the sight aligns with the fixed front sight.
When folded down, the lengthwise groove in the cantilever can
be used as a sighting plane, aligning with the front fiber optic
sight for extremely fast sighting situations. The rear sight is
adjusted for elevation using the two small screws found on the
rearward side of the rear sight. Loosen them slightly and move the
sight blade up or down to adjust the sights. Move the blade up to
move point of impact up. Move the blade down to lower point of
impact. Windage adjustment is accomplished by moving the front
(or rear) sight in the dove tail. Carefully tap with a hammer using
a non-metal drift against the sight base. Follow the instructions
provided with any accessory sight to install the sighting system.
For service or repair call for the location of the Authorized
Repair Center near you: 1-203-789-5000.
For information on obtaining parts go to the Winchester
Firearms website at: www.winchester-guns.com.
For general questions or comments call: 1-800-945-5237.
Line up the protrusion with the recess in the
forearm.
FIGURE 2
Fold-down sight on the cantilever.
FIGURE 3
01-198_WFA_Super X2, Practical 7/21/03 1:48 PM Page 2