Winchester Repeating Arms Super X2 Practical Supplement (Historic Manual) - Manual (Page 4)

C HAMBER
The Super X2 Practical has a 3" chamber and is for 2 3/4" and 3"
shells (12 gauge) only (primarily designed for 1 1/4 oz. and heavier).
This includes all but extra-light loads. Follow all instructions and
warnings regarding ammunition and chamber length found in your
full Super X2 Manual.
D ISASSEMBLY .
Your Super X2 Practical comes fully assembled in its supplied,
padded, protective case. To disassemble, follow the general
instructions found in the full Super X2 manual along with these
important additions.
1. Make sure your gun is fully unloaded. Keep the muzzle pointed
in a safe direction as explained in the full Super X2 owner’s manual.
2. Lock the action rearward.
3. Unscrew the magazine cap.
4. Remove the foreword magazine sleeve from the magazine by
sliding it forward, off the tube.
5. Slide the forearm forward, fully over the extended magazine tube.
6. Remove the barrel by pulling it forward – staying in alignment
with the magazine – until the magazine bracket passes the end of
the magazine. Set the barrel aside.
7. Remove the gas piston, gas sleeve and sleeve spring by sliding
them forward off of the magazine tube one at a time as explained
in the full manual. Your gun’s barrel is fully disassembled
(See Figure 1).
8. For disassembly of the trigger group and other internal components
follow instructions and warnings in the full Super X2 manual.
R EASSEMBLY .
1. Follow all instructions for assembly of the trigger group and
bolt assembly as described in the full Super X2 manual.
2. Insert the sleeve spring, gas sleeve and piston – in that order –
on the magazine tube as explained in the full manual.
3. To reinstall the barrel, align the barrel with the magazine tube
and inset the gas bracket over the magazine tube and slide rearward.
Align components as explained in the full manual. Be careful to
position the cantilever in alignment with the receiver before the
barrel extension reaches the receiver as you slide the barrel rearward.
It may require some careful positioning the first time to learn how
to line up all the components as they come together.
4. With the barrel fully in the correct position replace the forearm
as shown in the full Super X2 manual, sliding it from the end of
the magazine all the way into position.
3
FIGURE 1
01-198_WFA_Super X2, Practical 7/21/03 1:48 PM Page 5