Winchester Repeating Arms Supreme (Historic Manual) User Manual
Page 26
C
HOKE TUBE RIM CODES AND PATTERNING
—
Rim
Pattern With
Pattern With
Notches
Lead Shot
Steel Shot
Extended**
X-Full Turkey
**
I
Full
*
II
Imp. Modified
Full
1
III
Modified
Full
1
IIII
Imp. Cylinder
Modified
IIIII
Skeet
Imp. Cylinder
No Notches
Cylinder
Cylinder
• Not for use with steel shot. Using an over-tight choke constriction with steel
shot will result in an ineffective “blown” pattern.
** Extra Full Special , extended with ports. Do not use with steel shot.
1When more than one choke designation is listed for a given steel shot pattern,
use the more open choke listed for high velocity, larger shot size steel loads.
C
HANGING
L
ENGTH OF
P
ULL
(S
PECIAL
M
ODELS
)
Some Winchester Supreme shotguns are fitted with a
special trigger shoe system that allows you to make small
adjustments to the length of pull. This feature is usually
found on target models where shooters benefit from
highly customized settings.
It is easy to change the length of pull using the 1.5 mm
allen (hex head) wrench included with your gun.
BEFORE PERFORMING THIS ADJUSTMENT,
ALWAYS MAKE CERTAIN THERE ARE NO SHELLS
IN THE CHAMBERS AND THE SAFETY IS IN THE
“ON SAFE” POSITION.
1. Place your gun on its side on a secure, padded surface to
prevent marring the finish.
2. Using the allen wrench provided (any good 5/64" hex
wrench will work) loosen the trigger shoe from the trigger
plate by inserting the wrench from the bottom into the
set screw head (See Figure 19). Turn in a counterclock-
wise direction to loosen.
3. When the screw is sufficiently loose you will be able to
move the trigger shoe along the trigger plate with your
fingers. There are indexing dots on the trigger shoe and
on the plate. Line up the dots to make length of pull
longer or shorter as desired (See Figure 20).
4. Tighten the allen screw to secure the trigger shoe to
the plate (turn in a clockwise direction to tighten).
Make sure you have aligned the indexing dots in order to
prevent marring the bottom of the trigger plate with the
set screw.
5. With your gun unloaded, and pointed in a safe direc-
tion, shoulder your gun several times to see how the
24
Supreme Manual 01/01 7/17/03 11:00 AM Page 24