ORBIT FR RCS Pylons - Manual (Page 8)

8
Pylon ordering information
Pylons can be ordered from our selection of stan-
dard models or can be customized to suit customer
specifi c requirements.
To order a complete pylon assembly follow the example in the
table below.
Note the series number of the pylon model, the number
representing the ogive aspect ratio, and the number of feet for
the height of the pylon.
Options
• Slip rings with up to 30 contacts on the azimuth
axis (depends on rotator’s size)
• Rotary joints for “HAT” type rotators: 12 GHz,
18 GHz, 26 GHz and 40 GHz
• Service connector with static cover on top
of the "HAT" type rotators
• Special mounting holes and interfaces
are available upon request
• Special tilting device for installation or
removal of the pylon
Basic models:
• 28xxx-xxx – complete pylon
assembly, hat type
• 282xx-xxx – tip and rotator
only, hat type
• 2806x-xxx – complete low
profi le pylon rotator
• 2826x-xxx – tip and rotator
only, low profi le
Aspect ratios:
• 4 – 1:4 ogive ratio
• 6 – 1:6 ogive ratio
• 7 – 1:7 ogive ratio
Pylon heights:
• Pylon heights from 3 ft to
70 ft are available in standard
sizes in 1 ft increments.
• Pylon heights requiring ½ ft
increments start from 3 ft are
available upon request
Basic model series Aspect ratio Pylon height
AL-28007-150 7 11
Example: AL-28007-150-7-11
www.microwavevision.com / Contact us at: [email protected]
© MICROWAVE VISION 2012
Product specifi cations and descriptions in this document are subject to change without notice.
Actual products may differ in appearance from images shown.