OSRAM SYLVANIA ProPoint Industrial Linear LED Luminaire - Manual (Page 4)

Rev 110907-7
ProPoint™ Industrial Linear LED Luminaire manufacturers recommended installation instructions
4
Fig 7:
Wiring diagram (use sensor)
Fig 8:
Wiring diagram (do not use sensor)
Dimming
WARNING: ONLY QUALIFIED PERSONNEL SHOULD PERFORM INSTALLATION
TO AVOID ELECTRICAL SHOCK OR COMPONENT DAMAGE, DISCONNECT POWER BEFORE PERFORMING
INSTALLATION OF THE POWER SUPPLIES, MODULES, AND/OR RGB CONTROLLERS.
Failure to install the power supplies and/or LED modules in accordance with the National Electric Code (NEC), all applicable
Federal, State, and local electric codes as well as the specific Underwriters Laboratories (UL) safety standards for the installation,
location and application may cause serious personal injury, death, property damage and/or product malfunction.
These instructions are guidelines for installation of LED modules and power supplies. Installation requirements may vary depending
on the application. Licensed electricians should provide all installation services for connection for both primary and secondary
(input/output) of the power supplies.
Identification and Warnings of Safety Hazards
In accordance with ANSI Z535.4-2002 the following system of identifying the severity of the hazards associated with the products is
used:
“DANGER”: Imminently hazardous situation which, if not avoided, will result in death or serious injury.
“WARNING”: Potentially hazardous situation which, if not avoided, could result in death or serious injury.
“CAUTION”: Potentially hazardous situation which, if not avoided, may result in minor or moderate injury or property damage. Also
used to alert against unsafe practices.
IGNORING A HAZARD WILL VOID ANY WARRANTY
.