LaMotte 2020i Turbidimeter - Manual (Page 37)

PC LINK
The 2020 may be interfaced with any Windows-based computer by using the LaMotte
SMARTLink 2 Program and Interface Cable (Code 1912-3 with 3.5 inch disk or Code
1912-CD with compact disk). The program will store test information and results in a
database. The meter may also be interfaced with an RS232 serial printer, using an
interface cable (Code 1772) and setting the printer configuration to the Output as
described below.
Output
RS232 compatible, asynchronous serial, 9600 baud, no parity, 8 data bits, 1 stop bit.
Computer Connection
RS232 interface connection, 8 pin mini-DIN/9 pin F D-submin. (Order Interface
Cable Code 1772).
BATTERY OPERATION
The 2020 may be operated on battery power or using an AC adapter. If using the
meter as a bench top unit, use the AC adapter if possible. If using the meter only on
battery power, always keep a spare battery on hand.
Replacing the Battery
The 2020 uses a standard 9-volt alkaline battery that is available worldwide. The
battery compartment is located on the bottom of the case.
To replace the battery:
1. Open the battery compartment lid.
2. Remove the battery and disconnect the battery from the polarized plug.
3. Carefully connect the new battery to the polarized plug and insert it into the
compartment.
4. Close the battery compartment lid.
PC LINK & BATTERY OPERATION`` 37