Vermont Casting 2479 - Manual (Page 17)

17
Dutchwest Non-Catalytic Convection Heater
30002291
6. Reposition the stove so the other front corner over-
hangs the pallet and remove the leg bolt from the
bottom of the stove. Align the leg with the bolt hole
in the bottom of the stove, and attach it with the bolt
and washer. Tighten securely.
7. Reposition the stove so the first rear leg can be at-
tached. Attach the leg using the procedure described
in Step 6. (Fig. 21)
8. Reposition the stove so the remaining leg can be
attached. Attach it using the procedure described in
Step 6. Remove the pallet from beneath the stove.
9. Remove the (4) 1/4-20 x 3/8” hex head bolts from
the mounting bosses and attach the bottom heat
shield using the same bolts.
Carefully move the stove to its final position. One way
to lessen the effort of moving the stove over smooth
flooring is to slide it on a piece of inverted carpet. Move
it slowly to ensure the floor is not scratched.
Retighten all leg fastening hardware.
ST815
back leg
6/04
ST816
Fig. 21 Reposition stove so one rear leg can be attached.
Fan Kit Installation
1. Secure the fan assembly to the inner back with two
(2) 1/4-20 x 3/4” hex head screws and one (1) 1/4”
star washer as shown in Figure 22.
2. Attach snapstat to the mounting holes on the un-
derside of the bottom with two (2) 1/4-20 pan head
screws.
3. Attach the rheostat to the door handle insert holder
near the front left leg. Insert the rheostat control
shaft through the handle holder hole. Install the
retaining ring and rheostat knob onto the shaft.
4. Place cables where they won’t be harmed by traffic.
5. Fan will not operate until stove reaches approxi-
mately 109°F.
ST816
fan install
6/04
Rheostat
Knob
Rheostat
Snapstat
Pan
Head
Screws
Fig. 22 Fan installation.
ST813