Cecilware F-60 - Manual (Page 2)

To insert or replace the filter cartridge in the unit, follow these simple steps:
1) Remove cartridge support assembly by lifting straight up, and applying a twisting motion. Discard the
used cartridge. Wipe machine down with a clean cloth.
DO NOT USE WATER OR OTHER CLEANING SOLUTIONS WHEN CLEANING
THE FRY-SAVER®.
2) Place the cartridge support assembly over the center tube in the filter tank. Push down until the
cartridge support rests on the bottom of the tank.
3) Place the pleated filter cartridge (pleats facing up) over the cartridge support. Push down on the outer
rim until the cartridge rests on the support bead.
BE CAREFUL NOT TO DAMAGE PLEATS. Improper handling will crush them.
NOTE: Each filter cartridge can be used to filter up to 1,000 pounds of oil before a new cartridge must be
used. This equates to the cartridge being entirely covered with foreign matter.
It is recommended that you only remove and re-insert the cartridge when it needs to be replaced. By
continuously removing and re-inserting the cartridge, you will lessen its efficiency by breaking the seal
formed around the cartridge diameter. This allows for oil and particles to flow into the filtered oil and re-
contaminate the oil.
FILTER CARTRIDGE DIRECTIONS:
OPERATING INSTRUCTIONS
Before operating the filter, check the control lever and heater switch to see that they are in the "OFF"
position. The drain valve should be in the “CLOSED” position too. The filter cartridge should be inserted
as well (SEE FILTER CARTRIDGE DIRECTIONS).
NOTE: The FRY-SAVER® is equipped with a circuit breaker to protect against electric overload or short-
circuiting. If the unit is plugged in and does not operate, simply push the circuit breaker button located on
the face of the control panel and hold in for a few seconds. If the unit still does not operate, unplug and call
either a service technician or our office at 1-800-935-2211 or 718-932-1414. DO NOT CONTINUE TO
PUSH THE BUTTON! THIS WILL HARM THE MOTOR.
1) Turn off the fryer. Wait for the temperature of the oil to cool down to approximately 250° F. If you are
using solid shortening, see below.
2) Plug the FRY-SAVER® into the correct service outlet.
The FRY-SAVER® is equipped with an additional "pre-heat" feature for when the cooking oil is solidified
or thick.
A) Pre-heat the unit by turning the heater switch to "ON" and allow the unit to heat for
approximately 15 minutes. You will know the unit is ready because suction is felt at the
nozzle when the control switch is turned to "FILL."
B) When the machine is pre-heated, turn the heater switch to "OFF" and proceed with filtering.
Page 2