SARGENT 8200 Lever Lock - Manual (Page 2)

Inside Adapter & Plate Assembly
A7334F
2
3
A. Slide spindle (8) into lockbody hub
B. Slide adapter & plate assembly (7) over
spindle and secure with two #8-32 screws (6)
(do not tighten)
C. Tighten lockbody screws (13) on edge of
the door
D. Tighten both #8-32 (6) screws, securing
adapter & plate assembly
E. Position inside Escutcheon (5) and secure
with two 1/4-20 x 1-3/4" screws (4)
F. Place inside lever (1) horizontally onto lever
spindle (8). Hold lever firmly against the
escutcheon.
G. Use the 1/8" Allen wrench to tighten the set
screw (3) securely. Set screw should seat in
the groove of the inside adapter (7).
H. Pull on lever to verify set screw is seated
properly.
Copyright© 2005, 2008, 2010, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written permission of
Sargent Manufacturing Company is prohibited.
7
4 6
13
4
5
Cylinder retainer
access hole
12
11
3
1
I. With the cylinder flush to the
escutcheon face, rotate cylinder
to make the keyway vertical.
This ensures that the cylinder
retainer fork will line up with the
notch on the side of the cylinder.
J. Secure the cylinder with a #2
Phillips screw driver, using the
cylinder retainer access hole.
K. Test key & cylinder to verify
the lock is functioning correctly.
L. Secure Outside Front (12)
with two #8-32 screws (11) to
the lockbody.
INSIDE
INSIDE
OUTSIDE
OUTSIDE
LEFT HAND
LEFT HAND
REVERSE
BEVEL
RIGHT HAND
RIGHT HAND
REVERSE
BEVEL
DOOR HANDS DETERMINED FROM OUTSIDE
DOOR HANDING
Red color indicates locked
side of door Locking piece
slot
Lock
front
Latch
Hub
Note: Red surface of locking piece must face secure side of
door.
To rotate locking piece:
1.Position lockbody with red surface of locking piece visible
2.Insert blade type screwdriver into locking piece slot to rotate
locking piece
3.Push locking piece toward back of lock body and rotate 180°
until RED surface shows on opposite side
Note: Beveled surface of latch must face strike. The
deadlatch is self adjusting. To change hand of latch:
1. Insert screwdriver blade
into the spade shaped
slot
2. Rotate screwdriver 90º to push latchbolt out of the lock
case, until back of latchbolt clears lock front. Then
rotate latchbolt 180º allowing it re-enter the lockbody.
(Note: Latch can not be unscrewed)
How to Change Hand of Lock
Note: Functions 04, 06, 13, 17 and 31 require the following,
before the locking piece can be rotated:
(a) Remove the Green catch screw
(b) Rotate hub to make straight
(c) Rotate locking piece for required hand
(d) Red surface faces locked side of door
(e) Rotate hub to the original 45 degree position as shown
on lock case
(f) Reinstall the Green catch screw