SARGENT 8200 Lever Lock - Manual (Page 3)

Changing Hand Of Trim
A7334F
3
1. Loosen screw (1) and remove interlocking assembly (2).
See Figure A.
2. Unscrew the lower through-bolt stud (11) with a 3/8" wrench.
Remove mounting plate (6) and mounting posts. Switch
mounting posts (7) so they occupy the opposite positions on
the mounting plate (6)
3. Note the original position of the extension spring (16) and
lower plate (9) in the escutcheon (14). Unhook the extension
spring from pin (13).
4. Remove spring (16), lower plate (9) and locking hub (8)
assembly together.
5. Detach extension spring (16) from lower plate (9) and locking
hub assembly (8). Flip lower plate on locking hub assembly
spindle so that the spring hole is on the opposite side.
Reattach hook end of spring to lower plate.
6. Unscrew cap screw w/spacer (12) using 5/32" Allen wrench.
Move to opposite hole and tighten firmly.
7. Rotate lever to position shown in Figure E for desired hand.
8. Tighten retaining nut (10) firmly by hand and then back off one
notch until pattern shown in Figure C appears.
9. Attach bottom of spring (16) (closed loop) to pin (13). Hold
lever horizontal while inserting locking hub assembly (8) and
lower plate (9) into retaining nut (10).
10. Refer to Figure E: Position hub (4) for required function and
hand, checking that spindle (5) is vertical. Note position of
interlocking assembly Hook when positioning hub. Reposition
spindle as shown in Figure D if necessary.
11. Place the interlocking assembly (2) into the escutcheon and
attach the bottom hook to the locking hub (8) as shown in
Figure B. Secure in place with screw (1).
Caution: Check that locking hub (4) moves freely by
rotating the hub spindle (5). If not, check that bottom
hook is engaged in locking hub (8).
12. Insert and secure mounting plate and mounting posts to
escutcheon with lower through-bolt stud (11).
Figure A
2 Interlocking
assembly
1
7
6
7
8
9
10
3
4
5
15
14
16
13 12
Bottom
hook
Figure B
Figure D
Figure C
RIGHT
HAND
SHOWN
TOOLS REQUIRED
Phillips screw driver
Wrench 3/8"
Allen wrench 5/32"
Function
05, 16, 36, 37, 38, 65
Function
24, 25, 26, 35, 39, 40, 66
11
Figure E
Note: 04, 17 & 31
function locks, the
outside lever is always
freewheel and inactive,
the key is used to
retract the latchbolt
Rotate and
press in
Pull out
Interlocking
assembly hook
Spindle
Hub
ALWAYS WEAR EYE PROTECTION WHILE WORKING
Copyright© 2005, 2008, 2010, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Sargent Manufacturing Company is prohibited.
R.H. L.H.
R.H.R. L.H.R.
R.H. L.H.
R.H.R. L.H.R.